Description
Characteristics
Description
Hitec HS-488HB Servo is based on the popular HS-485HB model, but with a number of improvements: a 25-tooth spline provides compatibility with a wider range of accessories, and an oversized 2.5mm Allen screw replaces the standard Phillips. The new potentiometer eliminates the mechanical stops, allowing full range of motion without the risk of servo lockup.
- Weight: 45g
- Type: Analog
- Output shaft type: 25-tooth spline
- Voltage range: 4.8V–6.0V
- No-load speed (4.8V): 0.22 sec/60°
- No-load speed (6.0V): 0.18 sec/60°
- Maximum torque (4.8V): 4.8 kgf.cm (66.6 oz.in)
- Maximum torque (6.0V): 6.0 kgf.cm (83.3 oz.in)
- Maximum range PWM: 553–2425μs
- Stroke per μs: 0.102°/μs
- Pulse amplitude: 3–5V
- Direction: Clockwise with increasing PWM signal
- Dead zone width: 8μs
- Motor type: 3-pole ferrite
- Feedback type: 5kΩ potentiometer
- Output shaft support: Upper ball bearing, lower bushing
- Gear material: Carbonite
- Wire length: 300mm
- Wire cross-section: 25 AWG
- Connector type: 3-pin TJC8 [MH-FC]
Characteristics
Brand
goBILDA®
FIRST category
FIRST ® Tech Challenge
Previously viewed
